EN 13411-3 Round Wire Rope End Stop 3.1 T And TKH Ferrules
Product Details
TKH Wire Rope End Stop Ferrule
,Wire Rope End Stop 3.1
,Round Stop Ferrule
Product Description
3.1 T AND TKH FERRULES TKH ferrule EUROPEAN STANDARD SYSTEM – EN 13411-3
GENERAL DESCRIPTION
The aluminium ferrules, type T and type TKH correspond to the European standard for turnback ferrules (also known as ferrule secured eye terminations, FSET). The standard is EN 13411-3. The ferrule system is specified in Appendix 1. The ferrules are extruded seamlessly over mandrel and the aluminium alloy is EN AW-5051A according to EN 573-3. There is a conical ferrule called TK which is similar to the TKH but without the inspection hole. The TK ferrule does not comply with the EN standard. If used in any application the selection table is the same as for TKH. Special care has to be taken when using the TK ferrule due to lack of inspection hole.
APPLICATIONS
The aluminium ferrules are the most commonly used ferrules on the market today. They have a vast variety of applications, especially in the lifting gear industry. The T ferrules and TKH ferrules are thoroughly specified and very well defined for many different wire rope applications. Four different cases are tested and verified according to the standard, EN 13411-3. The ferrules can be used for fibre core single layer wire ropes, steel core single layer wire ropes, rotation resistant wire ropes and spiral strand ropes. Always use new wire ropes.
THE CORRECT SIZE OF THE SLING EYE
If a thimble is not used, the distance from the swaged ferrule to the inner bearing point of the soft eye must be at least 15 x the wire rope diameter (D), as per the figure. The width of the eye without load shall be approximately half its length. When using a pin or a hook, the minimum eye size should be verified with the formulas below.
- The company TALURIT was built-up on a patented solution for mechanical splicing of wire ropes. TALURIT have been the pioneering company in this special field, developing effective methods and equipment for mechanical splicing ever since.
The company is privately owned and was established in 1948. The parent company is based in Gothenburg, Sweden with subsidiaries near Singen in southern Germany and in Barnsley, United Kingdom. They have subsidiaries in Ningbo, China and in Singapore.
TALURIT sell their products throughout the world and have representation in most industrialized countries. Stock of standard products are strategically situated around the world to cut lead times and to improve efficiency.
-
Anfeng Lifting & Rigging is authorized non-exclusive distributor in China for TALURIT swagers, aluminum ferrules, copper ferrules, stainless steel ferrules, carbon steel ferrules and more.About Anfeng Lifting & RiggingBased in Shanghai Free Trade Zone, Shanghai Anfeng Lifting & Rigging Ltd. is an experienced technical and sales company specialized in supplying webbing slings, round slings, wire rope and slings, chains, rigging accessories and more.Anfeng supplies steel wire ropes, wire rope slings, lifting chains and accessories, webbing slings, round slings, fall protection harness, typhoon resistant series products, lashing, offshore mooring lines, chain hoists, lever hoists, electric hoists, shackles up to 1500t, and lifting points.We have earned a reputation globally as a provider of high quality products, supported by our trained staff and high standard of QA/QC procedure and inspections. Our technical staffs make sure the products meet all safety and manufacturing requirements. Upon request, Anfeng provides customers with DNV-GL, CCS, ABS and other third-party inspection certificates.
-
Galvanized Steel 48mm 4 Way Wire Rope Slings, lift sling
48mm Four-leg steel wire rope slings, steel core, swaged wire rope with Flemish Eye Sleeve and Thimble, equipped with Master Link Four-leg wire rope sling assembly, steel core, Soft Eye and Eye Sling Product Description A Four-leg Wire Rope Sling Assembly contains four Soft Eye and Eye Slings, which are equipped with a thimble eye and pressed with a ferrule. Having thimbles at each end means a strong structural support. This lifting set can be used for a range of applications -
2 Tonne Single Layer Flat Webbing Sling , Green Endless Lifting Slings
2 tonne Single Layer Polyester Webbing Sling Endless Lifting Sling, Flat Webbing Description Webbing slings are flexible, lightweight and have a wide bearing surface. The sling can be rotated throughout its service life to minimise wear and avoid repetitive use damage. Our polyester webbing slings can be manufactured and supplied in the standard web sling format: Endless, Single layer, Double layers, or to a custom design. In order to guard the webbing from unnecessary wear -
Grade 80 Alloy Steel CK Chain Pulley Blocks , 4:1 1 Tonne Chain Hoist
1 tonne Chain Block TB competitive Chain Block TB with industrial performance Description Chain Block type TB is competitive manual chain block with industrial performance. They are manufactured by VITALI-INTL Lifting Equipment Ltd, according to European and American standards. The whole series of Chain Block type TB contains 0.5 tonne, 1 tonne, 1.5 tonne, 2 tonne, 3 tonne, 3.2 tonne, 5 tonne, 10 tonne, 15 tonne, 20 tonne and 30 tonne in load capacity. They are mainly -
800 Tonne Wide Body Shackles , ASME B30.26 DNV Bow Type Shackle
800 tonne Wide Body Bow Shackle with Safety Bolt, DNV type approval, high load capacity, with increased bow radius to improve life of sling Wide Body Shackle, high load capacity bow shackle with safety bolt Product Overview Compared to our standard bow shackles, Wide Body Shackles have an increased bow radius to improve the sling resistance to wear and tear and enable you to use a lighter wire rope to lift the same heavy load. Galvanization of the Wide Body Shackle ensures
